Do it yourself
Small valve with greater possibility.
Topic:
Drip and sprinkler irrigation.
Microirrigation.
We would like to bring to your attention one small detail - model PV micro-faucet. This is a two-position micro-faucet with one inlet and two outlets for a micropipe with a diameter of 3 / 5mm. 3 is the inner, and 5 is the outer diameter of the tube. The faucet is produced in the usual version, as well as with a limitation of the water flow rate to 20 liters per hour.
Model PV-20
A little green insert is just a water flow limiter.
The lower part, the faucet enters a standard plunger or tee, and pipes are put on the 2 branches at the top. The tubes are easy to put on, since the connection is tapered and has the appearance of a thread, which facilitates installation and makes the connection extremely reliable.
This miniature faucet is very convenient for mounting external drippers or sprinklers that are mounted on special adapters.
The cock can be inserted directly into a plunger or tee, or into a plunger on a 4/7 mm diameter extension tube. See the different mounting options below.
By varying the connection options, as well as the length of the tubes, it is possible to create various versions of micro-irrigation systems, especially for pot and ample decorative flowers and plants.
EG::
For the florist and landscape designer, such a device provides a good basis for a flight of imagination and the creation of reliable and invisible irrigation systems for various complex flower arrangements.
We invite you to take part in this section and talk about your creative experience. If you would like to share your successes, please contact our information department.