|
Controllers GEVA, are available for automation of irrigation systems for small farmers' fields, in gardens, country houses, planting systems, in landscape design, and for other purposes.
Controllers can be mounted directly on the body of the solenoid on the crane, or by using fasteners on the wall, panel or another vertical surface, as well as using a plastic clamp on the pipe diameter, 3/4 or 1.0 inch.
Controller with fasteners shown in the photo at right, and the installation of the controller to the solenoid housing in the photo on the left.
|
|
Controllers GEVA. Installation of the pipe:
The plastic clamp installed on the pipe. When installing the clamps, remove the two screws that fastened by its two halves, and disconnect them. Put the halves on the pipe and twist them with bolts.
When the clamp is installed, you can put the controller on the bar clamp. Installation is complete.
See the photo above.
|
|
Controllers GEVA-75. Installation on a wall or panel
The mounting plate is fastened to a wall or panel using four screws ..
A cylindrical mounting the controller has a special slot, which is coming close to the slots that are available on the mounting plate.
Push the controller on the mounting plate from the top down until it stops. Installation is complete.
See the photo above.
|
|
Controllers GEVA. Multi-channel. Installation on a wall or panel
The mounting plate is fastened to a wall or panel using four screws.
On the back of the controller has special grooves that coincide with the grooves of the plate and coming close to the grooves of the mounting plate.
Push the controller on the mounting plate from the top down until it stops. When the controller is installed correctly and completely until it stops, you hear clicking. Installation is complete.
See the photo above.
|
