GEVA-75 CONTROLLERS

Install yourself. DIY installation.

GEVA controllers are produced for automation of irrigation systems in small farm fields, in household plots, in summer cottages, in landscaping systems, in landscape design and for other purposes.
Controllers can be installed directly on the solenoid body on the tap, or using fasteners on a wall, panel or other vertical surface, as well as using a plastic clamp on a pipe with a diameter of 3/4 or 1.0 inch.

GEVA controllers. Installation on the pipe:

The plastic clamp is installed on the pipe. When installing the clamp, unscrew the two screws that hold the two halves together and separate them. Put the halves on the pipe and screw them together with bolts.
When the clamp is installed, you can put the controller on the clamp stand. Installation is complete.

GEVA-75 controllers. Installation on a wall or panel:

The mounting plate is attached to the wall or panel using four screws.
There is a special slot on the cylindrical mount of the controller, which fits tightly onto the grooves on the mounting plate.
Push the controller onto the mounting plate from top to bottom until it stops. Installation is complete.

GEVA controllers. Multichannel. Wall or panel mounting:

The mounting plate is attached to the wall or panel using four screws..
There are special grooves on the back of the controller that match the grooves of the plate and fit tightly onto the grooves of the mounting plate.
Push the controller onto the mounting plate from top to bottom until it stops. When the controller is installed correctly and completely until it stops, you will hear a click. Installation is complete.