September 24, 2023 DROP 1000-4A | Agrosheriff Shopping mall



Product may vary slightly from image representation.
Available Options
  • Model:TIF-1000-4А


Product description.

Automatic Control topping

DROP-1000-4A kit is designed to work in the open field and in greenhouses.

Kit drip irrigation with automatic control for areas ranging from 10 to 20 ar (1000-2000 sqm) Irrigated area dependent on the width and inter-row planting scheme.
Kit allows four independent watering irrigation zone automatically. 
Kit is supplied as completely assembled units, allowing quick mount system by connecting it to the water supply via a flexible hose or plastic tube 25 mm in diameter.

  1. Drip tube LIN series
  2. filtration unit
  3. Management Automatic Block
  4. Fittings for the installation of irrigation systems
Drip tube LIN-16
filtration unit

Drip irrigation tube

Drip irrigation tube with built-in drips model LIN diameter of 16 mm, a water flow of 1.6 liters per hour for each dropper distance between drippers 30 cm and a wall thickness of 0.25 mm (10 mils).

Technical characteristics of the tube:

  • Model: LIN 16-1,6-0.30-0.25 (10mils)
  • Operating pressure 0.3-1.5 atm.
  • The maximum length of 1 line, not more 90 meters.
  • Service life - up to 3-5 years.

To reduce the weight of the kit, with international shipping by airmail EMS, used lightweight packaging for reels with drip tube.

*** In large farms such a tube is often used as a "one-off", but careful handling it quite work out long-term resource inherent in it. For more efficient operation of a reconstruction set includes connectors that allow to connect the tube pieces in the case of mechanical damage.

Infiltration block.

Filtratsiis manual washing unit , a necessary component of an irrigation system purifies water and protects the system from clogging.
The presence of two filters and the parallel connection allows to increase the total area of the filter element to reduce the filter pressure loss and increase the total flow rate through the filtration system of up to 10 cubic meters per hour, and the use of just such a configuration, the filtering unit easily and with minimal time wash unit filter without disassembling the filter, greatly reducing the time for system maintenance and support filters clean. Filters included in the box may be circular or sieve - by the customer. 
We are constantly improving our systems of irrigation and filtration unit that you get in the package, may slightly differ in appearance from the one shown in the photo, but it does not affect the functionality.
The filtering unit can be connected to a water source via pipes or flexible plastic reinforced plastic hoses. The filtering unit can be connected to a water source, and also by a threaded connection. All the necessary parts are supplied.


End of the line
Repair connector Remkonnektor


Needed to connect the drip irrigation tubes to the backbone tube. Startkonnektory equipped with taps which allow if necessary to enable or disable the watering on separate lines.

The end caps

The end caps (end of line) used for what would drown out the end of each individual drip irrigation lines. Mounted on the ends of a dropping tube.


Repair connectors are used for the repair of drip irrigation tubes in mechanical damage and if you change the configuration or irrigation scheme, and you need to connect the individual pieces of pipe in a single line.

compression connector

It is intended for connection to the filtration unit and automatic metering and distribution pipelines. The diameter of the pipes or hoses - 25 mm. (One inch).

Why not plug eg a piece of wire or rope?

We recommend to wash the drip tube at least once in 1-2 weeks. Such preventive flushing significantly extend the life of the irrigation system and save your money. At the end of the irrigation season, before you remove the system from your site, drip tube obyazatno need to rinse . The end cap allows to perform this operation quickly and easily, without mechanical damage to the end of the tube.


Name Count

Drip tube LIN 16-1,6-0.30-0.25 (10mil)

900 m

filtration unit

1 PC.


50 pcs.

The end caps

50 pcs.


10 pieces.

Compression connector NL251M

1 PC.
Node irrigation management. 4 zone automatic control. 1 PC.

Irrigation systems DROP 1000 all models are available directly from Israel. Delivered to any country in the world. Shipping cost is determined by the force at the time of delivery rates.

NOTE: Please select the filter option that you want to use for your irrigation system. You can select the filter with a filter element of the mesh or disc filters.

  • Model:TIF-1000-4А

Available Options

You might also like...

Greenhouse Teden-500
Greenhouse Teden-500

Здорово мне нравится!Я хочу такую строить. Просчитаю как по ...