Set DROP-1000-1A .

Drip irrigation system with automatic control.

Automatic control of irrigation

Node irrigation management. 1 irrigation area with automatic control.

Product description.

Kit for drip irrigation with  automatic  control of portion size from 10 to 20 ar (depending on planting scheme). It allows one irrigation watering zone in  automatic  mode (note: check debit available water source and its ability to provide the required water flow rate while all watering area).
Kit is supplied as completely assembled units. This allows you to quickly and easily assemble the system by connecting it to the water supply using a garden hose or plastic tube diameter of 25 mm.

The package includes a standard set for DROP-1000 components and spare parts: 

Drip tube LIN-16

Drip irrigation tube with built-in drips

model LIN diameter of 16 mm, with the water flow of 1.6 liters per hour for each dropper distance between drippers 30 cm and a wall thickness of 0.25 mm (10 mils).

The technical characteristics of the tube :
Model: LIN 16-1,6-0.30-0.25 (10mils)
Operating pressure of 0.3-1.5 atm.
The maximum length of 1 line, not more 90 meters.
Service life - up to 3-5 years.

To reduce the weight of the kit, with international shipping by airmail EMS, used lightweight packaging for reels with drip tube.
*** In large farms such a tube is often used as a "one-off", but careful handling it quite work out long-term resource inherent in it. For more efficient operation of a reconstruction set includes connectors kotrye allow the connection tube pieces in the case of mechanical damage.



filtration unit

Filtration unit with hand washing.

Infiltration block , a necessary component of an irrigation system purifies water and protects the system from clogging.

The presence of two filters and the parallel connection allows to increase the total area of ​​the filter element to reduce the filter pressure loss and increase the total flow rate through the filtration system of up to 10 cubic meters per hour, and the use of just such a configuration, the filtering unit easily and with minimal time wash unit filter without disassembling the filter, greatly reducing the time for system maintenance and support filters clean momoyanii.

Filters included in the box may be circular or sieve - by the customer.
We are constantly improving our systems of irrigation and filtration unit that you get in the package, may slightly differ in appearance from the one shown in the photo, but it does not affect the functionality.
The filtering unit can be connected to a water source via pipes or flexible plastic reinforced plastic hoses. The filtering unit can be connected to a water source, and also by a threaded connection. All the necessary parts are supplied.



end of line

Startkonnektor with a crane.

Needed to connect the drip irrigation tubes to the backbone tube. Startkonnektory equipped with taps which allow if necessary to enable or disable the watering on separate lines.

End caps liniyKontsevye drip caps (end line) are used for what would drown out the end of each individual drip irrigation lines.

Mounted on the ends of a dropping tube.

Rem connectors

Repair connectors are used for the repair of drip irrigation tubes in mechanical damage and if you change the configuration or irrigation scheme, and you need to connect the individual pieces of pipe in a single line.

Compression connector NL251M

Intended for connection to the block filtering and automatic metering and distribution of polyethylene pipe or soft plastic hose. The diameter of the pipes or hoses - 25 mm. (One inch).

Why not plug eg a piece of wire or rope?

We recommend to wash the drip tube at least once in 1-2 weeks. Such preventive flushing significantly extend the life of the irrigation system and save your money. At the end of the irrigation season, before you remove the system from your site, drip tube obyazatno need to rinse . The end cap allows to perform this operation quickly and easily, without mechanical damage to the end of the tube. 




Drip tube LIN 16-1,6-0.30-0.25 (10mil)


filtration unit

1 PC.

Startkonnektor with crane

50 pcs.

The end caps

50 pcs.


10 pieces.

Compression connector NL251M

2 pcs.

Node irrigation management. 1 area with automatic control. 1 PC.


Irrigation systems DROP 1000 all models are available directly from Israel. Delivered to any country in the world. Shipping cost is determined by the force at the time of delivery rates.

NOTE: Please select the filter option that you want to use for your irrigation system. You can select the filter with a filter element of the mesh or disc filters.

  • Model:TIF-1000-1А

Related Articles

Russian English Bulgarian Hebrew